Passive infrared motion detector for indoor areas. Upon triggering by a movement of heat, a switching command is sent. The properties can be configured.
· Can be set as individual device, main unit, auxiliary unit.
· Switching of operating mode between illumination and signal mode (signal mode: A specific number of movements must be detected in a specified time interval before a telegram is sent)
· Additional switching object in signal mode
· Behaviour upon switching to signal mode can be configured
· In illumination mode, the functions switching, value transmitter and
light scene execution can be set.
· Brightness-independent motion detection can be set
· Behaviour after bus voltage recovery can be set
· Status LED
· Go-test function for checking of the reception area (brightness independent)
· Alarm function for removal of top unit automatic control switch
· Resetting of alarm object upon replacement of the top unit
· Telegram type at beginning and end of reception can be set
· Cyclical transmission
· Block function can be configured for the beginning and end of blocking (own communication object)
· The brightness value can be set (blockable via ETS) within the limits
set in the ETS (3 - 100 lux) via the built-in potentiometer
· Sensitivity can be set via potentiometer
· Additional delay time can be set via potentiometer
· Switchable to continuous-on, continuous-off or automatic mode via slide switch (blockable via ETS).