Push button sensor 2, 6-gang (3+3) with controller with inscription space
The push button sensor is attached to one flush-mounted bus coupler. The following software variants (rocker or button application) are to be programmed with ETS 2:
• Push button sensor configurable with either 6 rocker or 12 button functions.
• Rocker functions: Switching, dimming, blinds, value transmitter/light scene auxiliary unit, analogue value transmitter and universal value transmitter EIS 6 to the 6 rockers
• Touch function, rocker functions only switching: ySwitching/pressingx or yno functionx to the 12 buttons or 6 rockers
• Status indication via 12 red LEDs possible
• Inscription space illumination ON, OFF, automatic switch-off or switchable via object
• Blocker for blocking individual buttons or rockers
• Alarm message after removal of the flush-mounted bus interface (1 bit/1 byte telegram)
• Switching/pressing function (ON, OFF, SW, no function)
• Dimming with stop telegram and telegram repetition possible
• Single-surface operation for rocker functions (switching/pressing, dimming) possible
• Blind press function (UP/DOWN) and operating concept (STEP – MOVE – STEP or MOVE – STEP) can be set
• Press functions of value transmitter EIS 6 (1 byte) or light scene execution with/without memory function
• Analogue value transmitter (EIS 5 or EIS 10), value adjustment possible by pressing and holding button
• Universal value transmitter EIS 6 for continuous run-through of a value range.
